HOW TO CHOOSE THE HOT MELT GLUE GUN

1.Please examine whether the power wire is in good condition and the bracket is provided and flow backwards with the adhesive gun handled.
2.The adhesives gun must be pre-heated before using, please don't place the glue gun erectly on the tables.
3.Please keep the surface of the hot melt adhesives strip and avoid pluging the mouth of guns up.
4.During the course of using the gun, if no glue comes from the mouth of the gun, please check the heat radiation of the gun;

The reason in abnormal heat radiation:
1 The power is not correctly inserted of the gun;
2 The gun is burned out for short circuit.

The reason in normal heat radiation:
1.When the mouth of the gun is pluged up by impurities, please contact professional personnel to repair it.
2. When the flow backwards occur leading to widen of the strip, you need to circumrotate the strip for a circle , tear a small moiety to shuck off the wider, continue to use it.
3.Before using the adhesive strip up, try your best not to draw the adhesive strip from the adhesive gun
4.When flow backwards occurs to the adhesive strip, please stop using the gun. after the professional personnel clean the refluent adhesives .